说明书 飞利浦 HQ6070 剃须刀

说明书

- Charge, use and store the shaver at a

temperature between 5°C and 35°C.

- Warning: Remove the detachable cord from

the handheld part before cleaning this part in

water.

- Be careful with hot water. Always check if the

water is not too hot, to avoid burning your

hands.

- Water may leak from the socket at the

bottom of the appliance when you rinse it.

This is normal and not dangerous because all

electronics are enclosed in a sealed power unit

inside the shaver.

- Do not immerse the shaver in water or

another liquid

- Do not use the shaver in combination with

pre-shave lotions, creams, foams, gels or other

cosmetic products.

General

- This shaver can be safely cleaned under the tap.

- This symbol means: Suitable to be cleaned

under a running tap (Fig. 4).

- The adapter transforms 100-240 volts to a safe

low voltage of less than 24 volts.

Compliance with standards

- This Philips appliance complies with all

standards regarding electromagnetic elds

(EMF). If handled properly and according to the

instructions in this user manual, the appliance

is safe to use based on scientic evidence

available today.

- This shaver complies with the applicable IEC

safety standards.

Charging

Make sure the appliance is switched off before you

start to charge it.

You can recharge the shaver between shaves, even

if the battery is not empty. This does not damage

the battery and prevents the battery from running

low during shaving.

Charging normally takes approx. 8 hours.

Do not leave the appliance connected to the

mains for more than 24 hours.

Charge indications

Charging

, When you start charging the shaver, the

battery symbol lights up (Fig. 5).

Battery running low

, HQ6076/HQ6075/HQ6073: When the

battery runs low, the red battery symbol

lights up. When you switch off the shaver, the

red battery symbol starts ashing. (Fig. 5)

, HQ6071/HQ6070: There is no indication

that the battery is low. The appliance switches

off automatically when the battery

is completely empty.

Charging the appliance

Charge the appliance when the red battery symbol

lights up or ashes (HQ6076/HQ6075/HQ6073)

or when the motor stops or starts running more

slowly (HQ6071/HQ6070).

1 Put the appliance plug in the shaver (Fig. 6).

2 Put the adapter in the wall socket.

3 When the battery is fully charged, remove

the adapter from the wall socket and pull

the appliance plug out of the shaver.

Cordless shaving time

A fully charged shaver has a cordless shaving time

of up to 40 minutes.

Using the appliance

Shaving

1 Press the on/off button once to switch on

the shaver.

The light ring lights up.

2 Move the shaving heads quickly over your

skin, making both straight and circular

movements (Fig. 7).

Shaving on a dry face gives the best results.

Your skin may need 2 or 3 weeks to get

accustomed to the Philips shaving system.

3 Press the on/off button once to switch on the

shaver.

4 To prevent damage to the shaving unit, put

the protection cap on the shaver after every

use (‘click’) (Fig. 8).

Trimming

For grooming sideburns and moustache.

1 Open the trimmer by pushing the slide

upwards (Fig. 9).

The trimmer can be activated while the motor is

running.

Cleaning and maintenance

Regular cleaning guarantees better shaving

performance.

The easiest and most hygienic way to clean the

appliance is to rinse the shaving unit and the hair

chamber with hot water every time you have used

the appliance.

For thorough cleaning of the shaving heads, we

advise you to use Philips Shaving Head Cleaning

Spray HQ110.

Every day: shaving unit and hair

chamber

Warning: Remove the detachable cord from the

handheld part before cleaning this part in water.

Be careful with hot water. Always check if the

water is not too hot, to prevent your hands from

getting burnt.

1 Switch off the shaver, remove the adapter

from the wall socket and pull the appliance

plug out of the shaver.

2 Press the release button (1) and open the

shaving unit (2) (Fig. 10).

3 Clean the shaving unit and the hair chamber

by rinsing them under a hot tap for some

time (Fig. 11).

Make sure the inside of the shaving unit and the

hair chamber have been cleaned properly.

4 Rinse the outside of the appliance (Fig. 12).

5 Close the shaving unit and shake off excess

water.

Never dry the shaving unit with a towel or tissue,

as this may damage the shaving heads.

6 Open the shaving unit again and leave it open

to let the appliance dry completely (Fig. 13).

You can also clean the hair chamber without water

by using the brush supplied.

Every six months: shaving heads

1 Open the shaving unit.

You can also pull the shaving unit off the shaver for

easier cleaning.

2 To remove the shaving heads, do the

following.

- HQ6076/HQ6075: Remove the retaining

frame and take out the shaving heads. (Fig. 14)

- HQ6073/HQ6071/HQ6070: Open the shaving

unit, turn the wheel anticlockwise (1) and

remove the retaining frame (2). Then take out

the shaving heads (Fig. 15).

3 Clean the cutters and guards with the brush

supplied (your shaving heads may differ from

the one shown in the gure) (Fig. 16).

Do not clean more than one cutter and guard

at a time, since they are all matching sets. If you

accidentally mix up the cutters and guards, it

may take several weeks before optimal shaving

performance is restored.

4 Put the shaving heads back into the shaving

unit and reassemble the shaving unit (Fig. 17).

- HQ6076/HQ6075: Make sure that the

projections of the shaving heads t into the

recesses when you put them back. Then place

the retaining frame back into the shaving unit.

- HQ6073/HQ6071/HQ6070: Put the shaving

heads back into the shaving unit. Put the

retaining frame back into the shaving unit and

turn the lock clockwise (your shaving heads

may differ from the one shown in the gure).

Note: If you removed the shaving unit from the

shaver, reattach it. First insert the hinge of the shaving

unit into the slot in the rim of the hair chamber and

then push the shaving unit home until it locks into

place (‘click’). (Fig. 18)

5 Close the shaving unit.

Trimmer

Clean the trimmer every time you have used it.

1 Switch off the shaver, remove the adapter

from the wall socket and pull the appliance

plug out of the shaver.

2 Clean the trimmer with the brush

supplied (Fig. 19).

3 Lubricate the trimmer teeth with a drop of

sewing machine oil every six months (Fig. 20).

Storage

- To prevent damage to the shaving unit, put the

protection cap on the shaver (‘click’) (Fig. 8).

- HQ6076/HQ6075/HQ6073: Store the

appliance in the pouch.

Replacement

To maintain optimal shaving results, replace the

shaving heads every two years.

Replace damaged or worn shaving heads with

HQ8 Precise Cutting System Shaving Heads.

1 Switch off the shaver, remove the adapter

from the wall socket and pull the appliance

plug out of the shaver.

2 Open the shaving unit.

You can also pull the shaving unit off the shaver.

3 To remove the shaving heads, do the

following.

常见问题

有关本说明书的更多信息

我们知道，为您的 飞利浦 HQ6070 剃须刀 提供纸质手册是件好事。 您随时可以从我们的网站下载该手册并自行打印。 如果您想要原始手册，我们建议您联系Philips。 他们也许能够提供原始手册。 您是否正在寻找其他语言版本的 飞利浦 HQ6070 剃须刀 手册？ 在我们的主页上选择您的首选语言并搜索型号以查看我们是否有可用。

规格

飞利浦 剃须刀 的所有手册
剃须刀 的更多手册

关于 飞利浦 HQ6070 剃须刀 的常见问题

我们的支持团队将搜索有用的产品信息并回答常见问题。如果您在常见问题中发现不准确的回答，请使用联系表格告知我们。

相关产品

说明书

飞利浦 AT790 AquaTouch 剃须刀

说明书

飞利浦 MVL3798 Marvel Spider-Man 剃须刀

说明书

飞利浦 RQ1275 SensoTouch 剃须刀

说明书

飞利浦 AT800 AquaTouch 剃须刀

说明书

飞利浦 RQ330 剃须刀

说明书

飞利浦 PT874 剃须刀

说明书

飞利浦 BRL146 剃须刀

说明书

飞利浦 BG2026 Bodygroom 剃须刀

相关类别