说明书 飞利浦 HQ988 剃须刀

说明书

General

- This shaver can be safely cleaned under the tap.

- This symbol means: Suitable to be cleaned

under a running tap (Fig. 4).

- The adapter transforms 100-240 volts to a safe

low voltage of less than 24 volts.

Compliance with standards

- This Philips appliance complies with all

standards regarding electromagnetic elds

(EMF). If handled properly and according to the

instructions in this user manual, the appliance

is safe to use based on scientic evidence

available today.

- This shaver complies with the applicable IEC

safety standards.

Charging

Make sure the shaver is switched off when you

start to charge it.

When you charge the shaver for the rst time

or after a long period of non-use, let it charge

continuously for 16 hours. Charging normally takes

approx. 8 hours.

For optimal performance, only charge the shaver

when the battery is low.

Do not leave the appliance connected to the

mains for more than 24 hours.

Charge indications

Charging

- When the shaver is charging, the charging light

lights up green continuously (Fig. 5).

Battery low

- HQ916: the charging light lights up orange

continuously.

- HQ988/HQ915/HQ912: the motor stops or

starts running slower.

Charging the appliance

Charge the appliance when the charging light lights

up orange (HQ916) or when the motor stops or

starts running slower (HQ988/HQ915/HQ912).

1 Put the small plug in the shaver (Fig. 6).

2 Put the adapter in the wall socket.

, The charging light goes on to indicate that

the appliance is charging (Fig. 5).

Note: Charge the shaver for at least 8 hours but not

more than 24 hours.

3 Remove the adapter from the wall socket and

pull the small plug out of the shaver when the

battery is fully charged (Fig. 7).

Note: The shaver does not run from the mains. When

the battery is empty, you have to recharge the battery

before you can use the shaver again.

Cordless shaving time

When the shaver is fully charged, it has a shaving

time of approximately 30 minutes.

Using the appliance

Note: The shaver cannot be used directly from the

mains.

1 Remove the protection cap.

2 Press the on/off button to switch on the

shaver (Fig. 8).

3 Move the shaving heads over your skin. Make

both straight and circular movements (Fig. 9).

Note: Shave on a dry face only. Do not use the shaver

in combination with gel, foam or water.

Note: Your skin may need 2 or 3 weeks to get

accustomed to the Philips shaving system.

4 Press the on/off button to switch off the

shaver.

5 Clean the shaver after every shave (see

chapter ‘Cleaning and maintenance’).

6 Put the protection cap on the shaver

to prevent damage and to avoid dirt

accumulation in the shaving heads (Fig. 10).

Note: Make sure that the lug of the protection cap

covers the release button.

Cleaning and maintenance

Never use scouring pads, abrasive cleaning agents

or aggressive liquids such as petrol or acetone to

clean the appliance.

Clean the shaver after every shave to guarantee

better shaving performance. For the best cleaning

result, we advise you to use Philips Cleaning Spray

(HQ110). Ask your Philips dealer for information.

Note: Philips Shaving Head Cleaning Spray (HQ110)

may not be available in all countries. Contact the

Consumer Care Centre in your country about the

availability of this accessory.

After every shave: shaving unit and hair

chamber

Warning: Remove the detachable cord from the

handheld part before cleaning this part in water.

Be careful with hot water. Always check if the

water is not too hot, to avoid burning your hands.

1 Switch off the shaver, remove the adapter

from the wall socket and pull the small plug

out of the shaver.

2 Rinse the outside of the shaving unit under a

hot tap for some time (Fig. 11).

3 Press the release button (1) and pull the

shaving unit in a straight upward movement

off the shaver (2). (Fig. 12)

4 Rinse the inside of the shaving unit under

a hot tap for some time (Fig. 13).

5 Rinse the hair chamber under a hot tap for

some time (Fig. 14).

6 Put the shaving unit back onto the

shaver (Fig. 15).

Every two months: shaving heads

Note: Do not use cleaning agents or alcohol to clean

the shaving heads. Only use Philips Cleaning Spray

(HQ110).

1 Switch off the shaver, remove the adapter

from the wall socket and pull the small plug

out of the shaver.

2 Press the release button (1) and pull the

shaving unit in a straight upward movement

off the shaver (2) (Fig. 12).

3 Turn the orange wheel anticlockwise (1) and

remove the retaining frame (2) (Fig. 16).

4 Remove and clean one shaving head at a

time. Each shaving head consists of a cutter

and a guard (Fig. 17).

Note: Do not clean more than one cutter and

guard at a time, since they are all matching sets.

If you accidentally mix up the cutters and guards,

it may take several weeks before optimal shaving

performance is restored.

5 Remove the guard from the cutter (Fig. 18).

6 Clean the cutter with the short-bristled side

of the cleaning brush. Brush carefully in the

direction of the arrows (Fig. 19).

7 Clean the guard with the long-bristled side of

the cleaning brush (Fig. 20).

8 Put the cutter back into the guard after

cleaning (Fig. 21).

9 Put the shaving heads back into the shaving

unit (Fig. 22).

10 Put the retaining frame back into the shaving

unit (1) and turn the orange wheel clockwise

(2) (Fig. 23).

11 Put the shaving unit back onto the

shaver (Fig. 15).

Storage

Store the appliance in a dry place.

Store the appliance at a temperature between 5°C

and 35°C.

1 Switch off the shaver.

2 Put the protection cap on the shaver after

use to prevent damage and to avoid dirt

accumulation in the shaving heads (Fig. 10).

Note: Make sure that the lug of the protection cap

covers the release button.

Replacement

Replace the shaving heads every two years for

optimal shaving results.

Replace damaged or worn shaving heads with

Philips HQ56 shaving heads only.

For instructions on how to remove the shaving

heads, see chapter ‘Cleaning and maintenance’,

section ‘Every two months: shaving heads’.

Accessories

To retain the top performance of your shaver,

make sure you clean it regularly and replace its

shaving heads at the recommended time.

Shaving heads

- We advise you to replace your shaving heads

every two years. Always replace them with

Philips HQ56 shaving heads only (Fig. 24).

Cleaning

- Use Philips Cleaning Spray (HQ110) to clean

the shaving heads thoroughly.

Environment

- Do not throw away the appliance with the

normal household waste at the end of its life,

but hand it in at an ofcial collection point for

recycling. By doing this, you help to preserve

the environment (Fig. 25).

- The built-in rechargeable battery

contains substances that may pollute the

environment. Remove the battery before you

discard and hand in the appliance at an ofcial

collection point. Dispose of the battery at an

ofcial collection point for batteries. If you have

trouble removing the battery, you can also take

the appliance to a Philips service centre. The

staff of this centre will remove the battery for

you and will dispose of it in an environmentally

safe way (Fig. 26).

常见问题

有关本说明书的更多信息

我们知道，为您的 飞利浦 HQ988 剃须刀 提供纸质手册是件好事。 您随时可以从我们的网站下载该手册并自行打印。 如果您想要原始手册，我们建议您联系Philips。 他们也许能够提供原始手册。 您是否正在寻找其他语言版本的 飞利浦 HQ988 剃须刀 手册？ 在我们的主页上选择您的首选语言并搜索型号以查看我们是否有可用。

规格

飞利浦 剃须刀 的所有手册
剃须刀 的更多手册

关于 飞利浦 HQ988 剃须刀 的常见问题

我们的支持团队将搜索有用的产品信息并回答常见问题。如果您在常见问题中发现不准确的回答，请使用联系表格告知我们。

相关产品

说明书

飞利浦 HP6370 Double Contour Ladyshave Sensitive 剃须刀

说明书

飞利浦 PT786 剃须刀

说明书

飞利浦 PT711 剃须刀

说明书

飞利浦 PT875 剃须刀

说明书

飞利浦 PT923 剃须刀

说明书

飞利浦 RQ1260 SensoTouch 剃须刀

说明书

飞利浦 HP6342 Ladyshave 剃须刀

说明书

飞利浦 PT725 PowerTouch 剃须刀

相关类别