说明书 OlightS80 Baton闪光灯
需要OlightS80 Baton闪光灯说明书吗?您可在下方免费查看和下载PDF版说明书。此外还有常见问题、产品评分和用户反馈,确保您能以最佳方式使用产品。如果这不是您需要的说明书,请联系我们。
您的产品是否出现故障而说明书没能提供解决方案?请前往 Repair Café 以获得免费维修服务。
说明书
Loading…
S80 Baton maintains Olight S series’s simple, reliable and easy of use advantages. A customized 4000mAh
26650 lithium rechargeable battery inside, integrated charge port, output up to 750lumens. It is a preferred
flashlight for household illumination, outdoor and industry field application.
Olight Technology Co., Limited
www.olightworld.com
Tel: +86-755-3351 8606
Fax: +86-755-3380 0207
Email: service@olightworld.com
TM
Operator's Manual
LED Flashlight
S80 BATON
Diffuser
Holster
Customized 26650 Lithium
Rechargeable Battery
Supplied Accessories
Specification
2
4
5
6
3
Key-ring
Operation Instrution
Operator’s Manual ( this manual)
Charger
Warranty
1
9
7
size:147*105
TM
WE MAKE A DIFFERENCE
S80 Baton手电筒保持Olight S 系列简洁,坚固,易用等 内置定制4000毫安时 26650可充锂电,并具
有充电接口,手电输出达到750流明。 S80是家用照明,户外及工业领域应用的首选产品。
优异特征, 它
定制 26650 可充锂电池
即时点亮:关机状态下, 按下开关按键并保持1秒或以上, 按下时开,释放时关 。
开、关机: 按下开关按键并在1秒内释放。每次开机,手电输出在前次关机时记忆的亮度级。
改变模式: 开机状态下,按住开关按键并保持,手电输出亮度在"低-中-高"之间循环,释放按键
将选定当前的亮度。
暴闪模式: 快速连按开关按键二次(初始状态为关需按三次)。在暴闪状态下,按下开关,1秒内
释放,输出关闭;如超出1秒,输出记忆的亮度。
锁按键: 开机状态下,按下开关按键并保持,输出经历 “低-中-高”循环三次后自动关闭,
手电进入锁定状态;在锁定状态, 如开关按键被意外按下, 手电不会开机,开关按键
处的灯将点亮1秒。
解 锁: 在锁定状态,需快速连击按键三次解锁并开机。重新装入电池也会自动解锁。
充 电: 连接充电器到电源插板或墙壁插孔, 揭开手电尾端充电接口软塞,将充电器DC插头插
入。充电状态指示灯位于充电器。 指示灯显示状态:
红色 -- 充电进行中; 绿色 -- 充电完成或未连接手电。
充电完成后,将充电器从电源插板或墙壁插孔取下, 请拔出DC插头,并塞紧充电接
口软塞。
警告 充电完成后,请及时断开电源,勿将充电器长时间连接到市电;不充电
时,请勿将手电连接到充电器 。
更换电池: 请使用厂家提供的电池。 先逆时针方向旋开手电尾盖,将电池取出后,将入新电
池;电池正极朝向手电前端装入,然后旋紧尾盖。见以下电池极性标识图:
1 发光二极管
2 透镜
3 不锈钢攻击头
4 开关按键
5 筒身
6 尾盖
7 软塞固定螺钉
/ 钥匙环固定孔
8 充电接口
9 充电接口软塞
特 征
主体材料
攻击头材料
体 积
重 量
颜 色
反光杯
开 关
透 镜
发光二极管
电 池
输出亮度级 / 运行时间
特殊模式
峰值光强
最大射程
抗冲击
防 水
低电压提示 / 低压关机
充电器
充电时间
主动热管理
钥匙环孔
size:147*105
产品部件
随机配件
手电包
滤镜
钥匙圈
用户手册 (本手册)
充电器
保修卡
操作说明
规 格
规 格
6N01-T6 铝材,表面三级硬质阳极氧化
不锈钢
头部直径 39.6毫米 / 筒身直径 32.5毫米 / 总长度 154毫米
277克 (包含电池)
黑色
铝构造,橘皮反射面
侧按键,轻触开关 + 硅胶帽
钢化加硬玻璃,双面镀增透膜,单面防水膜
Cree XM-L
定制4000毫安时 26650可充锂电池
10流明 / 80小时 ; 180流明 / 8小时; 750流明 / 2小时
暴闪,10赫兹
16650 坎德拉
260 米
2米跌落, 6个方向,每个方向2次
IPX8
电压低于3.15±0.05伏时, 开关键键底部指示灯以间隔3秒闪两次的速度闪动,
同时亮度自动至低一级的档, 最低亮度档低于3.15 伏 时关断电源供应±0.05
输入电压:交流 100~240伏 50/60赫兹; 输出: 恒流恒压 1安掊 4.2伏
约5小时
采用热敏电阻测试内部温度,当内部温度达到约85度时,在10分钟内,
输出平滑下降到最大亮度的60% 然后稳定在这个亮度
位于尾盖底部软塞固定螺钉
Characteristics
Material
Bezel
Size
Weight
Color
Reflector
Switch
Lens
LED
Battery
Flux / Runtime
Special Mode
Peak beam intensity
Max Beam Distance
Impact Strength
Waterproof
Low Battery Prompt / LVSD
Charger
Charging time
Active thermal management(ATM)
Key-ring Hole
6N01-T6 AL, Class-III harden anodization treating
Stainless Steel
Head D39.6mm / Body D32.5mm / Total Length 154mm
277g ( with battery)
Black
Orange peel, aluminum machining
Side button switch
Hardened glass, double sides AR coating, single side anti-water coating
Cree XM-L LED
Customized 4000mAh 26650 lithium rechargeable battery
10 lm / 80h; 180 lm / 8h; 750 lm / 2h
Strobe 10hz, 750lm
16650cd
260meters
2 meters dropping, 6 directions, twice each.
IPX8
Input: 100 to 240 VAC, Output: CC/CV 1A, 4.2V
About 5 hours
Locating at fixing screw of soft-cover in the tail cap
Under off status, press the button switch and hold 1 second or above, the light turns on
at moment that the button switch is pressed and turns off when the button switch is
released.
Press then release the button switch within 1 second. Every restart, output brightness
keeps same as previous memorized brightness.
While on, press and hold the button switch, output will change by the order “Low-
Medium-High", releasing the button switch will froze the output at presented
brightness.
Quickly press the button switch twice (if initial status is off, triply press)。Under strobe
status, pressing then releasing the button switch whin 1 second will turn off the output, if
the hold time over 1 second, the light restores to memorized brightness
While on, hold the button switch until the light becomes off. Usually the output will
experience three loops of“Low-Medium-High”before entering into off; Under lock
status, the hidden lamp under the button switch will turn on 1 second while the button
switch is unexpectedly pressed, but the light will not turn on.
Triply click the button switch within 1 second or reinstall after taking out the battery.
Connect the charger to AC power source or wall socket, then discover the soft-cover
and insert DC plug of charger into the charge port. The indication of the charger displays
the charge status. See below:
Red -- charging in progress; Green -- completed or not connected 。
When charge completed, please take off the charger from AC power source or wall
socket, and pull out the DC plug , insert the soft-cover into his seat.
Don’t always connect the charge with AC power source after charge
completed, it may cause to fire. Don’t long time connect DC plug together
with the flashlight while no charge.
2
4
5
6
3
1
8
9
7
8
Specification
1 LED
2 Lens
3 Stainless Steel Bezel
4 Button Switch
5 Body
6 Tail Cap
7 Fixing Screw of Soft-cover
/ Key-ring Hole
8 Charge Port
9 Soft-cover
Parts of the Flashlight
Momentary On:
Turn ON/OFF:
Change Mode:
Strobe:
Lock Button Switch:
Unlock:
Charge:
Warning
Replacing Battery:
Please using the factory supplied battery. Firstly, counterclockwise unscrew and take
out the tail cap, then take out the battery and insert the fresh battery, the positive of
battery should towards the head of the flashlight. Refer to below figure
正极
充电输入正
负极( 充电输入负)
When internal MCU detects the inner temperature over 85℃,within next
10 minutes, it will make regular and controls the output smoothly drop
to 60% of maximum brightness, then staying at this brightness level
When battery voltage drops to , the lamp under the button
switch will flash twice per 3 seconds interval, and the output will
automatically jump to lower brightness level. If the flashlight is running at
low brightness level, MCU will shut off the power supply.
3.15±0.05V
Positive
Negative( Charge Input-)
Charge Input+
Loading…
常见问题
请给产品评分,告知您对OlightS80 Baton闪光灯看法。您是否希望分享对该产品的体验或提出问题?请在页面底部留言。有关本说明书的更多信息
我们知道,为您的 OlightS80 Baton闪光灯 提供纸质手册是件好事。 您随时可以从我们的网站下载该手册并自行打印。 如果您想要原始手册,我们建议您联系Olight。 他们也许能够提供原始手册。 您是否正在寻找其他语言版本的 OlightS80 Baton闪光灯 手册? 在我们的主页上选择您的首选语言并搜索型号以查看我们是否有可用。
规格
品牌 | Olight |
模型 | S80 Baton |
类别 | 闪光灯 |
文件类型 | |
文件大小 | 0.68 MB |
我们的支持团队将搜索有用的产品信息并回答常见问题。如果您在常见问题中发现不准确的回答,请使用联系表格告知我们。
设备中的电池被氧化了,我仍可以安全使用吗? 验证
Ja,该设备仍然可以安全使用。首先,取出氧化电池。切勿徒手操作。然后用蘸有醋或柠檬汁的棉签清洁电池盒。晾干并插入新电池。
有帮助 (102) 阅读更多
加入有关该产品的对话
您可以在这里分享您对 OlightS80 Baton闪光灯 的看法。 如果您有疑问,请先仔细阅读手册。 可以使用我们的联系表索取手册。